Recommended for pools up to 120'

JETMAX TURBO UNIQUE FEATURES INCLUDE:

• Virtually FREE of consumable “wear and tear” parts.
  
• 120’ floating cable to accommodate the largest pools.
  
• 2 Year Warranty on plastics, electronics and motors.
  
• At 18 pounds it is easy to handle, operate and remove from the pool.
  
• Cleans all commercial pools up to 120 feet long; in half the time of any other cleaner.
  
• Unique scanning pattern guides the cleaner to fully vacuum most pool floors in about 1 hour.
  
• Complete set of Filter Bags (1 Fine Filter / 1 Mesh Filter) to capture all types of debris.
  
• Perfect for the slopes, curls, and curves of Grecian, Kidney-shape, or gradient-walled pools.
  
• JetDrive Propulsion uses the water pressure from the Pump to move the unit. No Drive Motor needed!
  
• High-Volume Pump Motor increases cleaner suction, filtration, and Jet Drive propulsion speed.
  
• Obstacle Sensors to detect walls and objects in the pool. Magnetic sensors detect stopped motion.
  
• Non-scuff rubber wheels guide the momentum of the JetDrive Propulsion. No Belts or Tracks needed!
  
• Hydroscrub System power-washes debris from the floor with pressurized water. No Brushes needed!
  
• Pump has Thermostat Box to regulate temperature, prolong motor life and reduce service costs.
  
• Optional Pole attachment for manual use. Attach a standard extension pole and use as a manual vacuum.

New! Stay-Cool Power Supply with External Digital 1-9 hour adjustable automatic shut-off Timer.

• Adjustable Axle with Directional Guidance Screws to set the cleaning pattern appropriately for
  pool width.

Manual Guidance Attachment

• Position the Back Plate over the center of the JetMAX label on the back of the unit. (The back is the side with the stationary, non-sliding axle.)
  
  
• The Body should have four holes pre-drilled behind the JetMAX label. Use the Back Plate to easily identify, push through and open the holes.
  
  
• If the holes are not predrilled behind the label, use the holes in the Back Plate as a template to drill through the plastic Body.
  
  
• Place the Front Plate over the holes and insert the four screws provided.
  
  
• Remove the Bottom Lid Assembly from the unit, look within and locate the ends of the four screws inserted through the Front Plate.
  
  
• Align the Back Plate over the four screws, place it flush against the Body and install the four lock nuts onto the screws.
  
  
• While grasping the lock nuts inside of the cleaner, tighten all four screws using a Phillips-head screwdriver.
  
  
• Line up the holes of the Front Plate’s arms with the holes of the Handle Bracket and install the Clevis Pin.
  
  
• Slide the Lock Ring through the small hole in end of the Clevis Pin. The MGA installation is now complete.

Product Videos

Additional Photos

Printable PDF Brochure

Get the information you want now. Download the product information brochures via PDF. This requires
Adobe Acrobat Reader® software. If you wish to have a brochure mailed to you click here

Click here to download