Recommended for pools up to 45'

At the heart of every JetMAX Junior is the patented JetDrive Propulsion System. This unique valve system enables JetMAX Junior to vacuum dirt and debris into the filter bag and out of the pool while moving around your pool using a single high output pump motor. The Hydroscrub Power Wash System includes a high pressure impeller that forces pressurized water through tubes to the Hydroscrubber nozzles. Sharp streams of water power wash dirt and debris off the pool surface.

The revolutionary JetMax Junior pool cleaner features a unique onboard pump and filter design making it the only automatic vacuum that works without manual labor, hoses, poolside pumps, hoists, costly drive motors, or the familiar wear and tear components such as tracks, belts, and brushes. JetMax Junior vacuums 4,800 GPH of dirt and debris into its 2x-quart capacity internal filter bag (standard equipped with both 2-micron and mesh filter bags). The micro-filtered water is expelled, jettisoning JetMax forward similar to a jet ski. A portion of the filtered water is forced, under high pressure, from the pump motor through two tubes to the pool's surface, creating a power washing effect to flush difficult dirt and debris up and out of pool pores--where brushes can't reach--and into JetMax Junior. The result is the most reliable and fastest automatic vacuum on the market, cleaning most pools in just one hour.

Manual Guidance Attachment

• Position the Back Plate over the center of the JetMAX label on the back of the unit. (The back is the side with the stationary, non-sliding axle.)
  
  
• The Body should have four holes pre-drilled behind the JetMAX label. Use the Back Plate to easily identify, push through and open the holes.
  
  
• If the holes are not predrilled behind the label, use the holes in the Back Plate as a template to drill through the plastic Body.
  
  
• Place the Front Plate over the holes and insert the four screws provided.
  
  
• Remove the Bottom Lid Assembly from the unit, look within and locate the ends of the four screws inserted through the Front Plate.
  
  
• Align the Back Plate over the four screws, place it flush against the Body and install the four lock nuts onto the screws.
  
  
• While grasping the lock nuts inside of the cleaner, tighten all four screws using a Phillips-head screwdriver.
  
  
• Line up the holes of the Front Plate’s arms with the holes of the Handle Bracket and install the Clevis Pin.
  
  
• Slide the Lock Ring through the small hole in end of the Clevis Pin. The MGA installation is now complete.

Product Videos

Additional Photos

Printable PDF Brochure

Get the information you want now. Download the product information brochures via PDF. This requires
Adobe Acrobat Reader® software. If you wish to have a brochure mailed to you click here

Click here to download